NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your
working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•
Procedure
•
Post-requisites
Procedure
1. Route the display cable through the routing guides on the display panel.
2. Slide the display cable into the connector and press down the latch to secure the cable.
3. Slide the sensor-board cable into the connector on the sensor board and press down the latch to secure the cable.
4. Adhere the sensor-board cable tape.
5. Adhere the tape that secures the display cable to the display panel.
Post-requisites
1. Follow the procedure from step 4 to step 6 in
2. Replace the
display
assembly.
3. Replace the camera.
4. Replace the battery.
5. Replace the
base
cover.
Replacing the display cable
computer. After working inside your computer, follow the instructions in
"Replacing the display
panel".
Replacing the display cable
46
After
www.dell.com/
79