Chapter 20: Replacing The Heat Sink; Procedure; Post-Requisites - Dell Inspiron 13 7000 Service Manual

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
CAUTION: Incorrect alignment of the heat sink can damage the system board and processor.
NOTE: The original thermal grease can be reused if the original system board and heat sink are reinstalled together. If either
the system board or the heat sink is replaced, use the thermal pad provided in the kit to ensure that thermal conductivity is
achieved.
Topics:
•

Procedure

•

Post-requisites

Procedure
1. Place the heat sink on the system board.
2. Align the screw holes on the heat sink with the screw holes on the system board.
3. In sequential order (indicated on the heat sink), tighten the captive screws that secure the heat sink to the system board.
Post-requisites
1. Replace the battery.
2. Replace the base cover.
38 Replacing the heat sink
Replacing the heat sink
computer. After working inside your computer, follow the instructions in
20
After
www.dell.com/