Table of Contents
Advertisement
10.5 ERRORS
An error is a condition that stops the automation.
When an error occurs: the ERROR LED turns on with
a steady light.
When not in the programming menus, press the
+ +
and - - simultaneously to display the relative er-
ror code.
10 Errors
Board failure
01
SETUP incorrect/
05
missing
BUS 2easy de-
08
vice fault/con-
flict
BUS 2easy short
09
circuit/overload
Call BUS 2easy
12
FAIL SAFE
Test failed
13
Configuration
Error
14
Encoder 1 failure Make sure that the encoder is con-
17
Encoder 2 failure Make sure that the encoder is con-
18
Corrupted data
19
in memory
E045S
Perform RESET. If the problem
persists, replace the E045S.
Perform SETUP.
Check the addresses of the devices.
Check the connections of the
BUS 2easy devices that are con-
nected and registered.
Check the connections of the
BUS 2easy devices and repeat the
acquisition procedure if necessary.
FAIL-SAFE test of a device
failed. Check the connections,
programming, and that the pho-
tocell/sensitive edges are working
correctly.
Check the board configuration (basic
and advanced programming) and
if necessary carry out the SETUP
procedure.
nected properly. If the problem
persists, replace the encoder.
nected properly. If the problem
persists, replace the encoder.
Repeat BUS 2easy programming
and registration.
10.6 ALARMS
An alarm is a condition that does not affect the opera-
tion of the automation.
The ERROR LED flashes when an alarm occurs.
When not in the programming menus, press the
+ +
and - - simultaneously to display the relative
alarm code.
11 Alarms
Obstacle de -
20
tected Leaf1
Obstacle de -
21
tected Leaf2
LOCK fault
25
Consecutive ob-
stacles in open-
27
ing
Consecutive ob-
stacles in closing
28
R a d i o c o d e
30
memory full
Intrusion at-
31
tempt in pro-
gress
25
An obstacle that prevents the leaf
from moving has been detect-
ed. Remove the obstacle.
An obstacle that prevents the leaf
from moving has been detect-
ed. Remove the obstacle.
LOCK fault. Check the connec-
tion. Remove the cause of the
short circuit.
The programmed number of con-
secutive obstacles in opening has
been reached. Remove the obsta-
cle. If the problem persists, repeat
the SETUP.
The programmed number of con-
secutive obstacles in closing has
been reached. Remove the obsta-
cle. If the problem persists, repeat
the SETUP.
The radio memory is full.
Use an additional DECODER/XR2.
module if necessary.
An attempt to open the leaf manu-
ally has been detected. Start a
movement.
532373 - Rev.A
Advertisement
Table of Contents
