Table of Contents
Advertisement
EU DECLARATION OF CONFORMITY
The Manufacturer
Company name:
FAAC S.p.A. Soc. Unipersonale
Via Calari, 10 - 40069 Zola Predosa BOLOGNA
Address:
- ITALY
hereby declares under its own exclusive liability that the fol-
lowing product:
Description:
electronic equipment
Model:
E045S
complies with the following applicable EU legislations:
2014/30/EU
2014/35/EU
2011/65/UE
Furthermore, the following harmonised standards have been
applied:
EN 61000-6-2:2005
EN 61000-6-3:2007+A1:2011
EN 60335-1:2012+A11:2014+A13:2017
Other standards applied:
EN 13849-1:2015 CAT.2 PL "C"
EN 13849-2:2012
EN 60335-2-103:2015
Bologna, 01-08-2020
E045S
CEO
A. Marcellan
1. INTRODUCTION TO THIS
INSTRUCTION MANUAL
This manual provides the correct procedures and
requirements for installing E045S and maintaining it
in a safe condition.
When drafting the manual, the results of the risk
assessment conducted by FAAC S.p.A. on the entire
product life cycle have been taken into account in
order to implement effective risk reduction measures.
The following stages of the life cycle of the product
have been considered:
- Delivery/handling
- Assembly and installation
- Set-up and commissioning
- Operation
- Maintenance/troubleshooting
- Disposal at the end of the product's life cycle
Risks arising from installation and using the product
have been taken into consideration; these include:
- Risks for the installation/maintenance technician
(technical personnel)
- Risks for the user of the automation system
- Risks to product integrity (damage)
In Europe, the automation of a gate falls under the Ma-
chinery Directive 2006/42/EC and the corresponding
harmonised standards. Anyone automating a gate
(new or existing) is classified as the Manufacturer of the
Machine. They are therefore required by law, among
other things, to carry out a risk analysis of the machine
(automatic gate in its entirety) and take protective
measures to fulfil the essential safety requirements
specified in Annex I of the Machinery Directive.
FAAC S.p.A. recommends that you always comply
with the EN 12453 standard and in particular that you
adopt the safety criteria and devices indicated, without
exception, including the dead-man function.
This manual also contains general information and
guidelines, which are purely illustrative and not exhau-
stive, in order to facilitate the activities carried out by
the Manufacturer of the Machine in all respects with
regard to carrying out the risk analysis and drafting the
instructions for use and maintenance of the machine. It
should be clearly understood that FAAC S.p.A. accepts
no liability for the reliability and/ or completeness of
the above instructions. As such, the manufacturer of
the machine must carry out all the activities required
by the Machinery Directive and the corresponding
harmonised standards on the basis of the actual
condition of the locations and structures where the
product E045S will be installed, prior to commissioning
the machine. These activities include the analysis of all
the risks associated with the machine and subsequent
implementation of all safety measures intended to
fulfil the essential safety requirements.
2
532373 - Rev.A
Advertisement
Table of Contents
