Table of Contents
Advertisement
RADIO CONTROLS - RC/LC
■ Memorizing radio controls
1. On the board, press the
A) or the - - button (memorize OPEN B/CLOSE) and
release it when the corresponding RADIO Led
(RADIO1 or RADIO2) starts to flash for 20 s (time
available for the next steps).
2. Press and release the button on the radio control
to be memorised. The corresponding RADIO LED
on the board becomes steady for 2 s (memorisation
completed), then starts to flash again. Another
radio control can be memorised within 20 s.
The procedure ends after 20 s if no further radio
controls are memorised and the RADIO LED switches
off. To add additional radio controls, repeat the pro-
cedure from step 1.
■ Adding radio controls remotely
Use a LC/RC radio control that is already use by the
automation, without having to use the board.
1. Take a radio control that is already in use and move
close to the board.
2. Press buttons P1 and P2 simultaneously on the
radio control that is already in use and release
them when its LED starts to flash slowly for 5 s
(time available for the next step).
3. Press and release the button that has already been
memorized (the corresponding RADIO LED on the
board starts to flash for 20 s, the time available for
the next step).
4. Press the button to be memorised on the new
radio control (the corresponding RADIO LED on
the board becomes steady for 2 s to confirm the
memorization. It then starts to flash again and an-
other radio control can be memorised within 20 s).
The procedure ends after 20 s if no further radio con-
trols are memorised (the corresponding RADIO LED
switches off). To add additional radio controls, repeat
the procedure from step 1.
E045S
+ +
button (memorize OPEN
RADIO CONTROLS - DS
1. Set the required combination of the DIP switches
on the radio control (avoid setting them to all On
or all Off).
2. On the board, press the
A) or the - - button (memorize OPEN B/CLOSE) and
release it when the corresponding RADIO Led
(RADIO1 or RADIO2) starts to flash for 20 s (time
available for the next step).
3. Press and release the button on the radio control
to be memorised. The corresponding RADIO LED
on the board becomes steady for 1 s and then
switches off (memorisation complete).
4. To memorize other radio controls, it is possible
to set a DIP switch combination that has already
been memorised or repeat the procedure for new
combinations.
DELETING RADIO CONTROLS
!
This procedure cannot be reversed. It will delete ALL
radio control codes that have been memorised as
OPEN A and OPEN B/CLOSE. The deletion procedure
is only active in the automation status display mode
1. Press the - - button and do not release it until the
LED sequence has finished:
- after 5 s the RADIO2 LED starts flashing slowly
- after 5 s the RADIO1 and RADIO2 LEDS both start to
flash quickly (deletion in progress)
- after 5 s both the LEDs come on steadily (deletion
complete)
2. Release the button, both LEDs switch off after
approximately 10 s.
22
+ +
button (memorize OPEN
532373 - Rev.A
Advertisement
Table of Contents
