Ppds Font Error; Defective Flash Detected; Unformatted Flash Detected; Standard Network Software Error - Lexmark X940E User Manual

50 PPDS font error

•
Touch Continue to clear the message and continue printing.
•
The printer cannot find a requested font. From the PPDS menu, select Best Fit, and then select On. The printer
will find a similar font and reformat the affected text.
•
Cancel the current print job.

51 Defective flash detected

•
Touch Continue to clear the message and continue printing.
•
Cancel the current print job.

52 Flash full

•
Touch Continue to clear the message and continue printing.
Downloaded fonts and macros not previously stored in flash memory are deleted.
•
Delete fonts, macros, and other data stored in flash memory.
•
Upgrade to a larger capacity flash memory card.

53 Unformatted flash detected

•
Touch Continue to stop the defragment operation and continue printing.
•
Format the flash memory. If the error message remains, the flash memory may be defective and require
replacing.
54 Serial option <x> error
•
Check that the serial cable is connected correctly and is the proper one for the serial port.
•
Check that the serial interface parameters (protocol, baud, parity, and data bits) are set correctly on the printer
and host computer.
•
Touch Continue to continue printing.
•
Turn the printer power off and then back on to reset the printer.

54 Standard network software error

•
Touch Continue to continue printing.
•
Turn the printer power off and then back on to reset the printer.
•
Upgrade (flash) the network firmware in the printer or print server.
54 Network <x> software error
•
Touch Continue to continue printing.
•
Turn the printer power off and then back on to reset the printer.
•
Upgrade (flash) the network firmware in the printer or print server.
55 Unsupported option in slot <x>
1
Turn the printer power off.
2
Unplug the power cord from the wall outlet.
3
Remove the unsupported optional interface card or internal print server from the printer system board.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer power back on.
199