Parameter Change Notification - Lexicon DC-2 Protocol Manual

Lexicon, Inc.
DC-2/MC-1 Serial Communications Protocol
The DC-2/MC-1 includes 8 custom characters that are defined to display increments of a display block.
(i.e. Volume Bar) The custom characters are ASCII character codes 08 - 0F(hex). The codes are used as
follows:
'08' - left 1 bar
'09' - left 2 bars
'0A' - left 3 bars
'0B' - left 4 bars
'0C' - Full Cell
'0D' - Underscore
'0E' - right 3 bars
'0F' - not in use
7.1.3.3 HOST Response
The DC-2/MC-1 does not look for any response from the HOST.

7.1.4 Parameter Change Notification

DC-2/MC-1 will transmit predetermined parameter change notifications. If a parameter value is changed
due to any user action or system action the DC-2/MC-1 will transmit the current value of the parameter that
is changing.
7.1.4.1 Notification Packet Description
Application Header:
Command DC_PARAM_CHG_MSG
Data Count 2
Application Data:
Data[0] ParamId
Data[1] Value
7.1.4.2 Data Description
ParamId:
DataType:
Max:
Value:
Data Type:
Max:
Packet for the Parameter Id of this packet.
7.1.4.3 HOST Response
The DC-2/MC-1 does not look for any response from the HOST.
7.1.4.4 Supported System Parameters
The following parameters will be supported by this Parameter Change Notification:
Parameter
Current Effect
Mute
System Volume
Balance
Input Selection
Record/Zone 2 On/Off
Zone 2 Volume
0x04
0x02
nn
nn
Unsigned 8 bit integer
Set by the System Parameter Count in the "Unit Configuration Packet".
The Current Value for this system parameter.
Unsigned 8 bit integer
Set by the Max Value per the System Parameter Definition response
DC-2/MC-1 Parameter Name
PROGRAM
MUTE
VOLUME
LR_BALANCE
INPUT
RECORD_ENABLED
Z2_VOL
Printed on: 10/19/00
9 of 44