Lexicon DC-2 Protocol Manual page 13

Lexicon, Inc.
DC-2/MC-1 Serial Communications Protocol
7.3.4.3 Data Description
ProductId:
Software Type:
Software Level:
*Note: SW level indicates the status of the DC-2/MC-1 internal application software.
Software Major Revision: An unsigned integer value indicating the unit's major software version. The host
Software Minor Revision: An unsigned integer value indicating this units minor software version. Indicates
Protocol Major Revision: An unsigned integer value indicating the serial communication protocol major
Protocol Minor Revision: An unsigned integer value indicating the serial communication protocol minor
Total Number of System Parameters:
Total Number of Effects: An unsigned integer value indicating the maximum number of effects available
This unsigned 8 bit value describes the product.
Product ID
Lexicon Dc-2
Lexicon MC-1
JBL Synthesis SDP-3
An unsigned 8 bit value indicating the current configuration of the unit's
software. The following table shows the values assigned to the available types:
SW Type
THX
AC3
DTS
The following table shows the values assigned to the possible software levels:
SW Level
RELEASED
PRE_ALPHA
ALPHA
BETA
GAMMA
UNSUPPORTED
should use this information to determine if new effects, effect parameters, or
system parameters have been added or removed.
the units software operation has changed but effects, effect parameters, or system
parameters have not changed.
version. The host should use this value to determine if new commands,
notifications, or response packets have been added or deleted from this
specification.
version. The host should use this value to determine if the existing commands,
notifications, or response packets have changed in this specification
An unsigned integer value indicating the maximum number of
system parameters for this version of software. This should be used to determine
the data count for the "DC-2/MC-1 System Parameter Values Packet" and "Set
System Parameter Values Packet".
for this version of software. This should be used to determine the maximum
EffectId used in the "Get Effect Definition Packet", "Get Effect Parameter
Definition Packet", "Set Effect Name Packet" , and "Set Effect Parameter
Values Packet".
1
2
3
1
2
3
0
1
2
3
4
5
Printed on: 10/19/00
13 of 44