Leviton EZ-MAX User Manual page 34

To specify the amount of time used for timed inputs, change
configuration mode to Advanced, go to System Setting under
the configuration menu, then Global Defaults and change the
Tswit value. Valid settings are 1-254 minuntes
Page 24
• Momentary Timed - Upon the first press, turn on the assigned relays for
the specified amount of time. When the time elapses, control of the relays
is relinquished to other controls (which generally results in the relays
turning off.) If the switch is pressed a second time, the timer is reset.
• Maintained - Maintained inputs turn On the relays while the switch is
pressed, then turn off the relays when the switch is released
• Preset Off - Turns off all relays in the current preset group.
• Preset On - Turns on all relays in the defined preset group.
• Momentary On/Off - Momentary On/Off is used with switch inputs
connected to switches that have separate on & off outputs and in
coordination with our switch input adapter cards or switch input adapter
kits. These kits provide both the on and off signal on the same switch leg
AND require the switch input setting to be defined as Momentary On/Off
This optional step only applies when using the Preset On/Off Types
Step 4:
A S S O C I A T E P R E S E T
N E W N U M B E R :
• Z-MAX panels use associate preset groups to define the group of buttons
that are all a part of the preset group. All inputs that are part of the same
group number work together and only one of the inputs can be active at
any one point in time.
• If you have already defined a number for the group to which this input
belongs, select NO at this prompt and select the number.
• If you have not defined an associate preset group number or need to
create a new group, select YES at this prompt and then enter the new
number.
Relay assignment - There are two methods which can be used to assign
Step 5:
relays to switch inputs, "Quick" and "Menu."
• Quick method allows you to assign relays to this input by pressing the
override button adjacent to the relay. Note that only the LED indicates
status, relay state does not change.
N O