Modem Module Installation/Phone Line Connection; Modem Module Installation On Ez-Max Panels - Leviton EZ-MAX User Manual

Modem Module Installation/Phone Line
Connection
Many relay cabinet models have an optional modem which can be installed. The part
number for this modem is rac00-mod and generally is ordered separately from the
cabinet. When the modem module is installed, the additional functionality is available:
• Touch-Tone Remote Control from a telephone (TIM) - In this mode, you dial in to
• Remote Programing via computer Modem - In remote programming mode, you can
Installation of a modem is a two step process,

Modem Module Installation on EZ-Max Panels

Z-Max Advanced Programming & Systems Design Guide
Revision A:11/2005
the relay cabinet from a touch-tone telephone and activate/deactivate relays by
using different combinations of button presses on your telephone
dial in to your relay panel from a computer which operates our Z-MAX configuration
software. Once connected, the configuration software can be used to configure
your cabinet remotely.
Install the Modem Module
Step 1:
Connect the Telephone Line
Step 2:
Prior to touching any part of any electronics, make sure that you first
touch any grounded metal surfaces so that you can discharge any
build up of static electricity.
Loosen approximately 2 turns the right two screws of the keypad/control
Step 1:
module
Remove the left two screws of the keypad/control module
Step 2:
Carefully lift up and turn around the control module, exposing the modem
Step 3:
socket.
Remove the modem module from it's packaging, and install into the
Step 4:
modem socket by aligning the gold dot with the location shown in the
illustrations, aligning the pins into the socket, and then gently but firmly
pressing the modem into place. Reference the drawing below which
shows the correct orientating of the modem.
Re-Install the control module following the reverse of the above steps
Step 5:

Modem Module Installation/Phone Line Connection

rac00-sdg
Page 163