Ethernet Network Module Installation; Ethernet Module Installation On Z-Max 8, 24, & 48 Relay Panels - Leviton EZ-MAX User Manual

Ethernet Network Module Installation

Many relay cabinet models have an optional ethernet module which can be installed.
The part number for this module is rac00-eth and is generally ordered separately from
the cabinet. When the ethernet module is installed, the following additional
functionality is available:
• Upload/Download of Relay cabinet software
• Remote terminal based console access for diagnostics and control
• Upload/Download of relay configuration data.
Installation of an ethernet module is a two step process,
Ethernet Module Installation on Z-Max 8, 24, & 48 Relay
Panels
Z-Max Advanced Programming & Systems Design Guide
Revision A:11/2005
Install the Ethernet Module
Step 1:
Connect the Ethernet Line
Step 2:
Prior to touching any part of any electronics, make sure that you first
touch any grounded metal surfaces so that you can discharge any
build up of static electricity.
Disconnect Power from the cabinet
Step 1:
Locate the ethernet socket on your control module
Step 2:
Remove the ethernet module from it's packaging, and install into the
Step 3:
socket by aligning the gold dot with the location shown in the
illustrations, aligning the pins into the socket, and then gently but firmly
pressing the ethernet module into place. Reference the drawing below
which shows the correct orientating of the ethernet module.
Ethernet Network Module Installation
rac00-sdg
Page 167