Only a few commands are necessary to load the operating system.
commands available, type HELP.
Z-Max Advanced Programming & Systems Design Guide
Revision A:11/2005
Many of the commands listed are for trained personnel and used
improperly could render the Z-MAX cabinet inoperable. Therefore,
only use those commands listed below as described.
To transfer the new operating system file, issue the PUT command. In
Step 6:
most cases you will only want to upgrade the operating system. In this
case, use the "C" parameter following the PUT command.
Tap Enter. You will be prompted to begin the transfer from your terminal
Step 7:
program.
Updating Firmware
To see all
rac00-sdg
Page 111