Omron V680S Series User Manual page 151

SET MULTI-READER/WRITER OPERATION
Item name
Multi Reader/Writer mode
Group setting
IP address
Status
If you change any of the multi-Reader/Writer settings, restart the Reader/Writer. The new settings will be enabled after
the Reader/Writer is restarted.
You can register IP addresses for up to seven Slave Reader/Writers on this view. If you set the Multi-Reader/Writer
Mode to anything other than Disable and set the IP address for a Slave Reader/Writer, the Slave Reader/Writer will
become a Master Reader/Writer.
There can be only one Master Reader/Writer in any one group.
If you assign the IP addresses of the Reader/Writer from the IO controller, the IP addresses of the slave Reader/Writer
will change dynamically and may result in unexpected operation. Confirm that no problems will occur before you assign
the IP addresses from the IO controller.
Click this button to set
the displayed values.
Description
Sets the Multi-Reader/Writer Mode.
You can check the IP address of
Reader/Writers registered as Slave
Reader/Writers and the connection
status of all of the Slave Reader/
Writers.
You can set or check the IP addresses
of Slave Reader/Writers No. 1 to 7.
You can check the connection status
of Slave Reader/Writers No. 1 to 7
with the displayed colors.
Browser Interface
Setting range
Disable, Field extension
mode, or High-speed traveling
mode
-
-
Not registered: Gray
Connection failed: Red
Connection successful: Green
Section 6
Default setting
Disable
-
-
-
RFID System
149
User's Manual
(PROFINET)