Section 4
Preparations for Communications
Starting the Reader/Writer
Reader/Writer Starting Procedure
1.
Connect the Cable to the Reader/Writer.
Refer to Connecting and Removing the Reader/Writer Power Cable and Ethernet Cable in Section 3 Installation and
Connections for the connector method.
p.94
2.
Connect the power supply lines and the operation mode signal line in the Cable to the power source
and connect the RJ45 connector to an Ethernet port on the host device.
3.
Turn ON the power supply to start the Reader/Writer.
If the Reader/Writer starts normally, the RUN indicator will fast flashing green.
RFID System
98
User's Manual
(PROFINET)