Omron V680S Series User Manual page 103

Setting the IP Address of the Reader/Writer on the Engineering Tool
You can also use the Engineering Tool to set the IP address for the Reader/Writer. Refer to the manual
for your Engineering Tool for the specific procedure to set the IP address with the Engineering Tool.
If you assign the IP addresses of the Reader/Writer from the IO controller, the IP addresses that are specified for the
following Reader/Writer functions will change dynamically and may result in unexpected operation. Confirm that no
problems will occur before you assign the IP addresses from the IO controller.
• IP address of the copy destination Reader/Writer for the data copy function
• IP addresses of the Slave Reader/Writers for multi-Reader/Writer operation
Preparations for Communications
RFID System
Section 4
101
User's Manual
(PROFINET)