The Fastest response Time algorithm works as follows:
When a network session is created, the first outgoing packet of that particular session is duplicated to all
the available WANs.
When the first response is received from a remote server, any further traffic for this session will be routed
over that particular WAN connection for the fastest possible response time.
If any slower responses are received on other connections afterwards, they will be discarded.
12.5 Inbound Access
Inbound access is also known as inbound port address translation. On a NAT WAN connection, all
inbound traffic to the server behind the Peplink unit requires inbound access rules.
By the custom definition of servers and services for inbound access, Internet users can access the
servers behind Peplink Balance. Advanced configurations allow inbound access to be distributed among
multiple servers on the LAN.
Important Note
Inbound access applies only to WAN connections that operate in NAT mode. For WAN connections that operate in
dropin mode or IP forwarding, inbound traffic is forwarded to the LAN by default.
12.5.1 Servers
The settings to configure servers on the LAN are located at N etwork>Inbound Access>Servers .
https://www.peplink.com
102
Copyright @ 2019 Peplink