GRASS VALLEY Ignite SDC Series Instruction Manual page 49

Ignite SDC/HDC Robotic Camera Instruction Manual
Table 8. Other Settings
Selection
Synchro Scan
V Resolution
Baud Rate
Component
Aspect Ratio
Fan SW
Language
Description
(60.34 Hz to 15.75 kHz) This setting is possible only when the Shutter
Speed setting is at S/Scan.
Horizontal bar noise can be reduced by synchro-scan adjustment in shoot-
ing workstation scenes, for example.
*For luminance settings at each shutter speed and synchro-scan shutter
speed, refer to the following table.
Shutter Synchro
Speed Scan
OFF -
1/100 100.3 Hz
1/250 250.0 Hz
1/500 492.2 Hz
1/1000 984.4 Hz
1/2000 1.969 kHz
1/4000 3.938 kHz
1/10000 7.875 kHz
Normal: Normal image. (CCD storage will be by field storage. Recom-
mended for general use because sensitivity will decrease at the Fine set-
ting.
Fine: Vertical resolution increases. (Vertical resolution is raised without
increasing residual images by frame storage and electronic shutter.)
(1200bps, 2400bps, 4800bps, 9600bps)
Select a communication speed in controlling the camera from the com-
puter.
This enables RGB, Y/Pr/Pb or Y/C to be selected as the component signals
which are to be output from the I/F REMOTE connector.
Aspect ratio can be selected from 16:9 or 4:3.
OFF: Select this setting to stop the fan when its operating sound is found to
be bothersome in a studio or other such environment.
Auto: The temperature is detected automatically, and the fan starts operat-
ing when the temperature exceeds approx. 95 ºF (35 ºC). Under normal cir-
cumstances, the "Auto" setting is used.
English: Menu screen is displayed in English.Japanese: Menu screen is
displayed in Japanese.
Menu Selections
Required
Luminance
Ratio
1
2
4
8
16
32
64
160
49