GRASS VALLEY Ignite SDC Series Instruction Manual page 39

Ignite SDC/HDC Robotic Camera Instruction Manual
Table 2. Troubleshooting (Problem/Cause/Solution) Matrix
Problem
Tally
Cause
Poor quality video
Tally does not illuminate
Troubleshooting
Solution
Check video cable connected to back
of camera block.
Ensure DB9 connector at pan/tilt head
is connected and that the zoom/focus
cable is connected to the lens assem-
bly.
Ensure the Iris cable from the lens
assembly is connected to the hirose
circular connector at the back of the
camera block.
Use the SHOT Director to access the
camera Settings menu and verify all
menu selections. Refer to the JSC-
2300 SHOT Director Robotics Con-
troller Instruction Manual and
Appendix A-SD (NTSC) Camera
Block, Appendix B-SD (PAL) Camera
Block, or Appendix C-HD Camera
Block.
Replace camera/lens assembly.
Ensure the tally light is properly con-
nect to a tally controller.
Replace camera/lens assembly.
39