GRASS VALLEY Ignite SDC Series Instruction Manual page 25

Ignite SDC/HDC Robotic Camera Instruction Manual
CAUTION Ensure that the selected mounting surface and hardware can safely support
the weight of a fully assembled unit (approximately 55 lbs (29.95 kg)).
3. If ceiling/inverted mounting is required:
• Remove the L-bracket, rotate it 180 degrees, then re-attach it to the
robotic pan/tilt head.
• Attach a safety wire or chain, that can support the
weight of the fully assembled unit to one of the bolts in the pedestal
mount flange and secure the other end to a rigid part of the ceiling/
mounting location.
4. Attach the robotic pan/tilt head assembly to the selected mounting
location. Use the four mounting holes in the pedestal mount flange as
shown in Figure 7.
Installation Procedures
55 lb (29.95 kg)
25