Procedure:
– Tighten wheel bolts in a diagonal sequence to specified torque
(see table of test values and procedure guidelines
⇒ page 36
).
– If adapter for anti-theft wheel bolts was used from tool kit: Put
adapter back in tool kit.
3.20
Components of front and rear axles:
checking play, secure attachment and
protective boots
The following applies to all components shown below:
•
There must be no noticeable or visual play.
•
As a rule you can identify damage to the boots/drive shaft
boots by emerging grease.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
•
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
Check that retaining rings and spring-type clips are seated
with respect to the correctness of information in this document. Copyright by AUDI AG.
correctly.
Front axle
⇒ page 37
Rear axle
⇒ page 39
3.20.1
Front axle
Track control links and guide links:
– Check relative movement between wheel bearing housing and
track control link/guide link.
– Check boots of swivel joints -arrows- all around for damage
and make sure they are seated correctly.
Audi A8 2003 ➤
Maintenance - Edition 06.2014
3. Maintenance
37