Audi A8 2003 Maintenance Manual page 12

Audi A8 2003 ➤
Maintenance - Edition 06.2014
– Rear: Position support plates of lifting platform under plastic
mountings -arrow- on underside of side member trim.
Note
The location of the lifting points is indicated by markings stamped
on the side member trim.
2.1.1 Activating jacking mode
Procedure:
– Switch on ignition and activate MMI.
– Press function selector button
– Under »Systems«, navigate through following menu structure:
♦ adaptive air suspension
♦ SETUP
– Use MMI rotary pushbutton to select "Jacking mode" and set
to "on".
Note
Jacking mode is switched off again automatically once a
♦
speed higher than 15 km/h is reached.
If jacking mode is activated for a longer period of time, the
♦
pressure in the suspension struts may dissipate, thereby low‐
ering the vehicle. If necessary, start the engine briefly to
reactivate jacking mode.
8
2. Preparations
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
.
CAR