Audi A8 2003 Maintenance Manual page 62

Audi A8 2003 ➤
Maintenance - Edition 06.2014
♦ Used oil collection and extraction unit - V.A.S 6622 A-
♦ Torque wrench - V.A.G 1331- , measuring range 6 to 50 Nm
Table of tightening torques for installation:
Component/fastener
Oil drain plug on sump
Steps for removal:
– Remove noise insulation
Procedure:
– Place oil drip tray under engine sump.
– Unscrew oil drain plug of sump -arrow-.
– Drain engine oil from sump.
– Renew seal for oil drain plug.
– Screw oil drain plug into sump and tighten to specified torque
(see table of tightening torques for installation
Continue installation in reverse sequence.
3.39.6 12-cyl. petrol engine 6.0 ltr. MPI
Special tools and workshop equipment required
♦ Used oil collection and extraction unit - V.A.S 6622 A-
58
3. Maintenance
[Nm]
25
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ page 13 .
⇒ page 58 ).