Audi A8 2003 ➤
Maintenance - Edition 06.2014
Note
Only the key being checked may be inside the vehicle. Place
♦
all other keys out of transmission range.
If the key has not been matched, the engine will turn off after
♦
a few seconds. In addition, the warning lamp for the immobil‐
iser or the display "SAFE" will appear in the instrument cluster,
depending on the vehicle equipment.
3.38
Turbocharger: greasing rod linkage
Special tools and workshop equipment required
♦ Universal spray oil -G 000 115 A2-
♦ High-temperature paste - G 052 112 A3-
♦ Torque wrench - V.A.G 1783- , measuring range 2 to 10 Nm
♦ Or: torque wrench - V.A.G 1410- , measuring range 4 to 20
Nm
♦ Or: torque wrench - VAS 6854- , measuring range 5 to 13 Nm
Table of tightening torques for installation:
Component/fastener
Securing bolts for air cleaner (top
section)
Steps for removal:
– Remove engine cover panel
– Detach spreader clips -1- for suspension turret cover (right-
side) and remove bolts -2-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– Pull suspension turret cover out of retainers -arrows-.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Loosen bolts -arrows- for air cleaner (top section, right-side)
and detach it.
– Take out filter element and cover open air cleaner housing with
a clean cloth.
52
3. Maintenance
[Nm]
3.5
⇒ page 9
.