Audi A8 2003 ➤
Maintenance - Edition 06.2014
♦ Hose clip pliers - VAS 6362-
♦ Torque wrench - V.A.G 1410- , measuring range 4 to 20 Nm
Table of tightening torques for installation:
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
Fastener
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Bolt on bracket
Steps for removal:
– Remove fasteners -1- and unscrew bolts -2-.
– Remove suspension turret cover from retainers in direction of
-arrows-.
Step 1 - removing:
– Detach retaining clip -1-, then remove O-rings and regulating
valve -5- with fuel hoses attached.
– Use hose clip pliers to disconnect fuel supply hoses -2- and
-3-.
– Loosen bolt -4- on bracket and remove fuel filter.
Step 2 - installing fuel filter:
Install in reverse sequence. Note tightening torques (see table of
tightening torques for installation
Flow direction is indicated by arrows on filter housing.
104
3. Maintenance
⇒ page 104
).
Tightening torque
[Nm]
10