Pre-Configured Default Values; All Mx3 Mobile Devices - Se923, Se955; Figure 2-2 Pre-Configured Default Values - Symbol Scan Engines - LXE MX3 Programming Manual

16

Pre-Configured Default Values

Note: The SE955 scanner replaced the SE824 scanner on all MX7's manufactured after July 2006. It also
replaced the SE923 scanner on all MX3X and MX3-RFID devices manufactured after July 2006.
Mobile Device
MX3X and MX3Plus
MX3-RFID (laser)
MX5X
MX7
MX8
Figure 2-2 Pre-configured Default Values – Symbol Scan Engines
All MX3 Mobile Devices – SE923, SE955
All MX3s - Scanner Parameter
Set Default Parameter
Scanning Options
Aim Duration
Aiming Mode
Beeper Volume
Bi-directional Redundancy
Laser On Time
Linear Code Type Security Levels
Parameter Scanning
Power Mode
Raster Expansion Rate
Raster Height
Scan Angle (Clipping)
Scan Angle
Scanning Mode
Time Delay to Low Power
Time-out Between Different Symbols
Time-out Between Same Symbol
Transmit "No Read" Message
Trigger Mode
Integrated Scanner Programming Guide
SE824 SE923 SE955
x x
x x
x x
x
Default Value for SE923
SE1223 SE1224 SE1524
x x
Default Value for SE955
All Defaults
0.0 sec
Not Supported
Not Supported
Disable
3.0 sec
1
Enable
Low Power
Not Supported
Not Supported
No Clipping
Normal
Not Supported
Not Supported
Not Supported
1.0 sec
Disable
Level
Symbol Barcodes
SE2223
x
x
All Defaults
0.0 sec
Not Supported
Not Supported
Disable
3.0 sec.
1
Enable
Low Power
Not Supported
Not Supported
Not Supported
Wide
Not Supported
Not Supported
Not Supported
1.0 sec.
Disable
Level
E-SW-SCANNERPG-L