LXE MX3 Programming Manual page 140

124
Buffer All Symbols / Transmit Macro PDF When Complete activates transmission of all decode data
from an entire Macro PDF sequence. Transmission does not occur until the entire Macro PDF
sequence is scanned and decoded. This is the default option.
If the decode data exceeds the limit of 64K bytes, there is no transmission because the entire sequence
has not been scanned. Use the parameter Flush Macro PDF Buffer to purge the buffer.
Transmit Any Symbol in Set / No Particular Order causes transmission of data from each Macro
symbol as decoded, whether it is in sequential order or not.
Scan in Sequence Only / Transmit in Sequence Without Buffering causes transmission of data from
each symbol within the Macro PDF sequence as decoded, provided the Macro PDF symbols are
scanned in order. If you do not scan the symbols in order, an error occurs.
When Buffer Scans Out of Order / Transmit Scans in Order is enabled, decode data from each symbol
within the Macro PDF sequence is transmitted when decoded, provided that the Macro PDF symbols
are scanned in order. Decode data from symbols out of order in the Macro PDF sequence is buffered.
The decoder can buffer up to 64K bytes.
Integrated Scanner Programming Guide
Buffer All Symbols - Transm
Transmit Any Symbol in Se
Scan in Sequence Only
Buffer Scans Out of Order
Symbol Barcodes
Cancel
E-SW-SCANNERPG-L