LXE MX3 Programming Manual page 372

356
Revision E – June 2005
Entire Guide – Removed DOS mobile device-specific information. DOS mobile devices with integrated scanners'
instruction is contained in the "Integrated Scanner Programming Guide for DOS Devices" (E-SW-SCANDOSPG-
[Revision]).
Chapter 1 – Restructured for readability and to address frequent queries. Expanded section on obsolete mobile devices
with integrated scanners (DOS and LXE Legacy).
Chapter 2 -- Corrected barcodes for "Beep After Good Decode". Corrected description for "UPC/EAN Coupon Code /
UCC Coupon Extended Code".
Revision D – January 2005
Chapter 1 -- Added MX5 CE .NET and MX3 CE .NET devices to barcode valid scanner tables. Added "Cleaning the
Scanner Aperture".
Chapter 2 -- Added section titled "Aiming Modes" to the Symbol chapter explaining how to setup specific aiming patterns
for each engine. Added new SE1224 specific parameters: Beeper Frequency Adjustment, Scan Angle.
Chapter 4 -- Added SE1224HP scan ranges.
Revision C - March 2004
Chapter 1 – Removed MX4 information. Added MX6 imager information. Replaced incorrect Disable/Enable Code128
barcodes with the correct barcodes. Clarified final sentence in "How To" section. Added "Printing Barcodes from this
Guide" to Troubleshooting section.
Revision B - April 2003
Chapter 2 – Added MX5 specific information to "Identify Your Barcode Scanner Type", "Parity" and "Chapter 4 – Scan
Engine Technical Specifications." Removed SE2223 from Aim Duration. Added Aiming Mode, UPC Composite, RSS,
and Composite CC-C and CC-A/B barcodes for SE2223.
Chapter 4 – Added section titled "Initial Equipment Setup Barcodes". Revised scanning distances for 2325, MX2 and
MX2 w/Handle.
Revision A - January 2003, Initial Release
This guide contains barcodes that can be used to program integrated barcode laser scanner engines installed in LXE DOS
and Windows computers.
The information in this guide replaces the barcode setup chapters that were in the following equipment guides: 2325
Reference Guide, 2335 (MX1) Reference Guide, MX1 Reference Guide, MX1-IS Reference Guide, MX2 Reference
Guide, MX3 Reference Guide, and MX3-CE Reference Guide. See section titled "Getting Help" for the location of these
guides.
Integrated Scanner Programming Guide
Scan Engine Technical Specifications
E-SW-SCANNERPG-L