Pre-Configured Default Values - LXE E-SW-BLUESCANPG-B Manual

SE955 Laser Barcodes

Pre-Configured Default Values

Set Default Parameter
Scanning Options
Aim Duration
Aiming Mode
Beeper Volume
Bi-directional Redundancy
Laser On Time
Linear Code Type Security Levels
Parameter Scanning
Power Mode
Raster Expansion Rate
Raster Height
Scan Angle (Clipping)
Scan Angle
Scanning Mode
Time Delay to Low Power
Time-out Between Different Symbols
Time-out Between Same Symbol
Transmit "No Read" Message
Trigger Mode
UPC/EAN
UPC-A
UPC-E
UPC-E1
EAN-8
EAN-13
Bookland EAN
Decode UPC/EAN Supplementals
Decode UPC/EAN Supplemental Redundancy
Transmit UPC-A Check Digit
Transmit UPC-E Check Digit
Transmit UPC-E1 Check Digit
UPC-A Preamble
UPC-E Preamble
E-SW-BLUESCANPG-B
SE955 Parameter Default
All Defaults
0.0 sec
Not Supported
Not Supported
Disable
3.0 sec.
1
Enable
Low Power
Not Supported
Not Supported
Not Supported
Wide
Not Supported
Not Supported
Not Supported
Not Supported
Disable
Host
Enable
Enable
Disable
Enable
Enable
Disable
Ignore
7
Enable
Enable
Enable
System Character
System Character
Bluetooth Ring Scanner Guide
61