LXE MX3 Programming Manual page 249

5380SF 2D Imager - Imager Parameters – General
If centering is enabled, the imager only reads codes that intersect the centering window specified by
the user scanning the Top, Bottom, Left, or Right barcodes that follow.
Centering On
Scan Centering Off to turn the scan window centering option off. Scan the Save barcode.
Scan Centering On, then scan one of the following barcodes to change the top, bottom, left, or right
of the centering window.
Top of Centering Window
Left of Centering Window
Scan the percent to be used to shift the centering window by scanning 2 digits in a row using the
number symbols on the "Symbols 0-9" page at the end of this chapter, and scan Save. If you make an
error while scanning the digits (before scanning Save), scan the Discard barcode, scan the Centering
On barcode, scan the top, bottom, left or right barcodes, scan the correct digits, and then scan the
Save barcode again.
The default percent value for Top and Left is 40%, the default percent value for Bottom and Right is
60%.
E-SW-SCANNERPG-L
Bottom of Centering Window
Right of Centering Window
Integrated Scanner Programming Guide
233
Centering Off