Table of Contents
Advertisement
assembled on this day
Section 7..........................................................Maintenance and Servicing
2.3 Overhauling:
With normal daily operating spell, the pump will be due for overhaul after about 5000 working
hours. This work should be done by skilled personnel.
3. SPARE PARTS
3.1 Ordering of spares
The pump size and serial number are shown on the pump nameplate. When ordering spares the
nameplate should be referred and following information should be quoted:
1) Pump serial number
2) Pump size
3) Part name — (refer to spares parts list)
4) Part number — (refer to spares parts list)
5) Number of parts required
Pentair Southern Cross supplied spares should only
be used as replacements. Any change to the original
M
W
X
design specification (modification or use of a non-
genuine part) will invalidate the pump's safety and
warranty liability with Pentair Southern Cross.
Wear Rings
3.2 Recommended spares
W - Wear Rings Fitted
For start-up purposes:
Leave blank if none fitted)
PARTS
Seal and bearing kit
Mechanical seal or packing gland
Impeller washer
Casing 'O' ring
For normal maintenance:
PARTS
Seal and bearing kit
Wear rings (If installed in original pump)
Meachanical seal or packing gland
Shaft
Impeller
Impeller washer
Casing 'O' ring
4. MAINTENANCE SCHEDULE – 'ISO' PUMPS
The below schedule provides a suitable timetable to monitor pump and system performance, and will
provide a guide to pending maintenance requirements by comparing the current situation with previous
recordings.
Extreme or unusual operating environments should be taken into consideration, and shorter
maintenance intervals are recommended.
AUS ISO
ISO SOV
ISO PRO
Bearing Housing
X - Denotes Mk2 bearing
housing of 2013
(leave blank for older housing)
QTY
1
1
1
1
QTY
1
2
1
1
1
1
1
29
200
ISO PRO Centrifugal Pump
AUSGD2BE CZ2CP X
03K2013A09
50X32-200
180
PSFA1A CC4CP X
03K2013A01
150X125-315
304
PRHG3A CC4XOWX
bar
bar
bar
Advertisement
Table of Contents
