Table of Contents
Advertisement
Section 7..........................................................Maintenance and Servicing
6. DISMANTLING PROCEDURE
6.1 Tools required
A typical range of tools that will be required to maintain these pumps is listed below:
Open ended spanners
(wrenches) to suit up to 2"
(M50) screws/nuts
Tension wrench
Socket spanners (wrenches)
Socket sizes 28, 38, 48, 50 and
60 A/F
Metric Allen keys
(up to 10mm)
Screw driver set
Soft mallet
Metal wedges
Dial indicator
Shaft Locker
TOOL
31
ISO PRO Centrifugal Pump
WHERE USED
Undoing bearing cover
Pretensioning impeller nut
Undoing impeller nut
General disassembly
Removing and assembling
seals/gaskets
Soft loosening assembled parts
removing impeller off tapered
pump shaft
Checking impeller run-out
Holding shaft while undoing
impeller nut
Advertisement
Table of Contents
