Advertisement
Removing the loading base assembly
Prior to performing the following procedure, remove
the top cover, the front panel assembly and the main
tray assembly.
1.
Disconnect the wire from connector CN808, CN809
and the card wire from CN210 on the servo control
board respectively.
2.
Remove the seven screws E attaching the loading
base assembly.
Removing each board (See Fig.12 to 14)
Prior to performing the following procedure, remove
the top cover, the front panel assembly, the main
tray assembly and the loading base assembly.
Servo control board
1.
Pull out the relay board 2 on the upper side of the
body.
2.
Disconnect the wire from connector CN807, CN810
and CN910 on the servo control board respectively.
3.
Remove the screw G attaching the lug wire.
4.
Remove the three screws F attaching the servo
control board.
Relay board 1
1.
Disconnect the wire from connector CN842 on the
relay board 1.
2.
Remove the two screws G attaching the relay board.
A/V output board
1.
Pull out the relay board 2 on the upper side of the
body.
2.
Remove the four screws H attaching the A/V output
board.
3.
Remove the eight screws I on the back of the body.
Power board
1.
Disconnect the wire from connector CN952 and
CN953 on the power board.
2.
Remove the four screws J on the upper side of the
body.
3.
Remove the screw K on the back of the body.
Loading base assembly
(See Fig.11)
E
E
Relay board 1
Power
board
G
Power board
J
CN952
XV-F80BK/XV-F85GD
E
Servo control board
CN808
E
E
Fig.11
Rear panel
Lug wire
A/V output board
Relay board 2
CN810
F
CN842
CN807
CN901
Fig.12
A/V output board
J
H
Relay board 1
CN953
Fig.13
I
I K
Rear panel
Fig.14
CN210
CN809
F
Servo control
board
F
Rear panel
H
Relay board 2
Servo control
board
1-9
Advertisement
