Advertisement
XV-F80BK/XV-F85GD
Reattaching the main tray assembly
1.
Turn over the main tray assembly and pass the card
wire extending from the photo sensor board through
the notch b, in advance (Fig.8).
2.
From above the loading base assembly, turn the
load base counterclockwise until the slide gear stops
at the back end (Bring down the traverse mechanism
assembly).
3.
Reattach the main tray assembly to the loading base
assembly while fitting to the groove on the right and
left sides of the loading base assembly.
4.
Connect the card wire through the notch b to
connector CN841 on the relay board 1.
5.
Reattach the main tray assembly while fitting the slot
c to the shaft.
1-8
(See Fig.8 to 10)
Loading base assembly
Load base
Main tray assembly
Photo sensor board
Fig.8
Slide gear
Fig.9
Joint a
Boss
Relay board 1
CN841
Fig.10
Notch b
Slot c
Shaft
Advertisement
