Advertisement
XV-F80BK/XV-F85GD
Removing
the
assembly (See Fig.15 and 16)
Prior to performing the following procedure, remove
the top cover and the front panel assembly.
REFERENCE:
There is no need to remove the loading
base assembly.
1.
Eject the main tray assembly toward the front
referring to "Removing the main tray assembly".
2.
Remove the two screws L and pull out the clamper
base assembly upward.
3.
Disconnect the card wire from connector CN210 on
the servo control board.
4.
Remove the four screws M
mechanism assembly upward.
CAUTION:
When reattaching the traverse mechanism
assembly, pass the card wire extending
from the traverse mechanism assembly
through the notch d of the elevator base.
<Front panel assembly>
Prior to performing the following procedure, remove
the top cover and the front panel assembly.
Removing the power switch board
1.
Remove the two screws N on the back of the front
panel assembly.
2.
Disconnect the card wire from connector CN813 and
CN806 on the power switch board.
Removing the operation switch board
1.
Remove the six screws O on the back of the front
panel assembly.
2.
Disconnect the card wire from connector CN812 on
the operation switch board.
Removing the FL display board
1.
Remove the two screws P on the back of the front
panel assembly.
2.
Disconnect the card wire from connector CN805 on
the FL display board.
1-10
traverse
mechanism
and the traverse
(See Fig.17)
(See Fig.17)
(See Fig.17)
Clamper base assembly
L
Fig.15
M
Traverse mechanism
assembly
Fig.16
Operation switch board
O
O
P
FL display board
Fig.17
L
Servo control board
CN210
Notch d
Servo control board
CN210
M
CN813
O
CN812
N
CN806
CN805
Power switch board
Advertisement
