Advertisement
XV-F80BK/XV-F85GD
<Traverse mechanism unit>
Removing the pickup (See Fig.1 to 5)
It is not necessary to remove the traverse
mechanism unit.
1.
Solder soldering a on the flexible board next to the
pickup unit.
2.
From the bottom of the traverse mechanism unit,
disconnect the flexible wire from CN101 on the
pickup board.
ATTENTION:
Disconnecting the flexible wire without
soldering may cause damage to the
pickup.
3.
Remove the screw A attaching the shaft stopper (R)
on the upper side of the traverse mechanism unit.
Pull the side of the shaft stopper (R) outward to
release the joint b and remove it upward. Remove
the skew spring at the same time.
4.
Move the shaft in the direction of the arrow to release
it from the part c.
5.
Release the joint d with the shaft and remove the
pickup with the shaft.
6.
Pull out the shaft.
7.
Remove the screw B attaching the switch actuator.
B
Switch actuator
1-14
Shaft
Pickup
Fig.5
Traverse mechanism unit
Soldering a
Shaft stopper (R)
Pickup unit
Shaft
Joint d
A
Shaft stopper (R)
Shaft
Pickup unit
Flexible board
Fig.1
Pickup board
CN101
Flexible wire
Fig.2
A
Shaft
Part c
Fig.3
Shaft stopper (R)
Joint b
Skew spring
Fig.4
Advertisement
