Advertisement
XV-F80BK/XV-F85GD
Removing the belt / load base / slide
gear
Prior to performing the following procedures, remove
the elevator base.
1.
Remove the belt on the upper side of the loading
base assembly.
2.
Remove the screw R attaching the pulley gear.
3.
Remove the pulley gear, the gear 1, the gear 2 and
the belt respectively.
4.
Remove the screw S and the load base upward.
5.
Remove the two screws T
upward.
CAUTION: When reattaching the slide gear
and the load base,
1.
Move the slide gear toward the front until it stops
(Fig.23).
2.
Make sure that the part d of the load base is out of
alignment with the switch e and that the gear f is
disengaged from the slide gear.
Switch e
Part d
1-12
and the slide gear
Slide gear
Gear f
Fig.23
Belt
R
Pulley gear
Slide gear
Load base
Loading base assembly
Fig.20
Gear 2
Pulley gear
S
Load base
Loading base assembly
Fig.21
T
Fig.22
Gear 1
Advertisement
