Advertisement
XV-F80BK/XV-F85GD
Disassembly method
<Main body>
Removing the top cover (See Fig.1)
1.
Remove the two screws A on each side of the body.
2.
Remove the two screws B on the back of the body.
3.
Lift the rear part of the top cover and remove in the
direction of the arrow while pulling both sides of the
top cover outward.
Removing the front panel assembly
Prior to performing the following procedure, remove
the top cover.
1.
Disconnect the card wire from connector CN801 and
CN803 on the servo control board
the power board respectively.
2.
Remove the three screws C on the upper side of the
body.
3.
Remove the three screws D on the bottom of the
body.
Remove the front panel assembly toward the front.
1-6
Power board
(See Fig.2 and 3)
and CN951 on
,
Top cover
A
2
A
2
Fig.1
CN951
Front panel assembly
Fig.2
D
(Bottom)
Fig.3
B
Servo control
board
CN801
CN803
C
Front panel assembly
Advertisement
