Advertisement
XV-F80BK/XV-F85GD
Removing the photo sensor board and
the sub tray drive motor assembly
1.
Turn over the main tray assembly and remove the
two screws C attaching the photo sensor board.
2.
Disconnect the card wire from connector CN082 on
the photo sensor board.
REFERENCE:
Make sure to disconnect the card wire
from the photo sensor board. If the
photo sensor board is pulled out from
the main tray without disconnecting the
card wire, the cam switch side inside of
the main tray may be damaged.
3.
Remove the two screws D attaching the sub tray
drive motor assembly.
When reassembling,
Attach the two wires to the part d on the photo
sensor board, and before reattaching the photo
sensor board, connect the card wire to connector
CN082 and pass the card wire extending from
connector CN081 through the notch e of the main
tray.
1-18
(See Fig.4)
CN081
Part d
Photo sensor board
Sub tray drive motor assembly
D
C
CN082
Main tray
Card wire
Fig.4
D
Notch e
Advertisement
