Advertisement
XV-F80BK/XV-F85GD
Removing the turn table assembly
Prior to performing the following procedure, remove
the traverse mechanism unit.
1.
Disconnect the card wire extending from the turn
table assembly, from connector CN201 on the pickup
board.
2.
Remove the screw E attaching the shaft stopper (F)
on the upper side of the traverse mechanism unit.
Pull the side of the shaft stopper (F) outward to
release the joint h and remove it upward. Remove
the spring at the same time.
3.
Remove the screw F
assembly.
4.
Move the turn table assembly outward and pull out
from the shaft. Then remove it from the base chassis.
1-16
(See Fig.6, 8 and 9)
attaching the turn table
Shaft stopper (F)
Joint h
Traverse mechanism unit
Shaft stopper (F)
E
Turn table assembly
E
Shaft stopper (F)
Shaft
Shaft
Base chassis
Pickup board
CN101
CN201
Fig.6
F
Fig.8
E
Spring
Turn table assembly
Fig.9
F
Advertisement
