Advertisement
XV-F80BK/XV-F85GD
Removing the cam switch board assembly
Prior to performing the following procedure, remove
the main tray cover, the U/D cam (U) and the sub
trays.
1.
Remove the screw F
Release the two tabs marked p by pushing inward.
2.
Remove the cam gear (2) upward.
3.
Disconnect the card wire from connector CN083 on
the cam switch board assembly.
4.
Remove the two screws G attaching the cam switch
board assembly.
CAUTION:
When reattaching the cam gear (2), set the
position of the boss and the triangular mark
and hole as shown in Fig.17.
Arrow mark
Position the high tooth
and the arrow mark
1-22
(See Fig.15 to 17)
attaching the gear cover.
High tooth
F
Tabs marked p
Fig.15
G
Cam gear (2)
Fig.16
Hole
Triangular mark
Set the position of the boss
Fig.17
Gear cover
Cam switch board assembly
CN083
G
A hole and a triangular
mark become right above.
Advertisement
