Table of Contents
Advertisement
UM-PM-029
DA9213, DA9214, and DA9215 Performance
Boards
Figure 6: DUT Selection
6.1
Interface Indicators
Start Device
When pressed it automatically configures the register R327 CONFIG_E for standalone operation.
Polling Enabled
If disabled, the main read-backs from the device are suppressed. This is used to force the
communication over the bus to be silent.
If this is set to automatic, the program only polls the device while the application is the topmost
window. If obscured by another program or window, polling is disabled.
LED
If device is active this is green, otherwise it is red.
Interface
2
Select between USB I
C control, offline mode, and SPI. Switching to offline, then back to USB re-
initialises the USB interface.
USB OK?
The light indicates that the USB is fine and communicating.
Read Chip ID
These fields indicate the device version and trim status when the device is active. When inactive, the
version and trim status are not correct.
User Manual
Revision 2.0
25-Feb-2022
CFR0012
13 of 37
© 2022 Renesas Electronics
Advertisement
Table of Contents
