Configuration - Emerson Fisher FIELDVUE DLC3020f Quick Start Manual

Digital level controller for foundation fieldbus

Hide thumbs Also See for Fisher FIELDVUE DLC3020f:

Quick Start Guide

D103470X012

Configuration

Note

This quick start guide documents procedures in AMS Device Manager 10.5 and later. Earlier versions of AMS Device Manager

contain the same procedures and methods, but access is through the block in which they reside.

Note

The primary transducer block must be set to out of service before the device can be configured.

When using AMS Device Manager 10.1 and earlier go to Target Mode in Block Modes tab to set the primary transducer block in and

out of service. Refer to figure 9.

Figure 9. Block Modes Tab (AMS Device Manager 10.1 and earlier)

BLOCK MODES

CONFIGURE

Guided Setup

AMS Device Manager

Configure > Guided Setup

Device Communicator

Configure > Instrument Setup

Access Instrument Setup from the Guided Setup tab, as shown in figure 10, for sensor, device and process fluid setup.

Follow the prompts to setup the DLC3020f.

DLC3020f Digital Level Controller

SET THE TARGET

MODE TO OUT

OF SERVICE

April 2022

Table of Contents