Module Initial Startup; Initial Configuration - Emerson PACSystems RX3i IC695CPE302-B Series Quick Start Manual

Module Initial Startup

You Will Need:
•
PACSystems RX3i CPU Firmware 10.60 or later.
•
PAC Machine Edition™ configuration and programming software,
version 8.00 SIM 7 or later.
•
An IC693CBL316 serial or Ethernet cable for connecting the
computer running the PAC Machine Edition programmer to the RX3i
CPU.

Initial Configuration

1. Using PAC Machine Edition (PME) software, configure the
CPE302/305/310-Bxxx in an RX3i target.
Note: If you intend to use the module's embedded Ethernet
interface, you will probably need to assign it a new IP
address. To configure the embedded Ethernet interface in
Machine Edition, expand the CPU slot to display the
Ethernet daughterboard.
embedded Ethernet module contains IP Address, Subnet
Mask, and Gateway IP Address (see the following diagram).
Consult your network administrator for the proper values
for these parameters.
11 PACSystems™ RX3i IC695CPE302/305/310-Bxxx
The Settings tab for the
GFK-3249B