Advertisement
DLC3020f Digital Level Controller
April 2022
Features Selected
Note
Typically this parameter does not need to be changed. The unit will be operational using the default values assigned by the factory.
Features Selected indicates which Resource Block Options features have been selected and is used to select the
desired features.
Reports—Selecting reports enables alert and event reporting. Reporting of specific alerts may be suppressed.
Fault State—Selecting Fault State enables the ability of the output block to react to various abnormal conditions by
shedding mode.
Write Lock—When selected, permits using Write Lock to prevent any external change to parameter values. Block
connections and calculation results will proceed normally, but the configuration is locked.
Reannunciation— When selected, the instrument will support Reannunciation of alarms.
Alert Key
Alert Key is a number that permits grouping alerts. This number may be used to indicate to the operator the source of
the alert, such as the instrument, plant unit, etc. Enter a value between 1 and 255.
Maximum Alerts Allowed
The number of alert reports that the device can send without getting a confirmation up to the maximum permitted
Resource Block
Tag Description— The Tag Description is used to assign a unique 32 character description to each block within the
digital level controller to describe the intended application of the block.
Strategy— Strategy permits strategic grouping of blocks so the operator can identify where the block is located. The
blocks may be grouped by plant area, plant equipment, etc. Enter a value between 0 and 65535 in the Strategy field.
Transducer Block
Tag Description— The Tag Description is a 32 character description used to assign a unique description to each block
within the digital level controller to describe the intended application for the block.
Strategy— Strategy permits strategic grouping of blocks so the operator can identify where the block is located. The
blocks may be grouped by plant area, plant equipment, etc. Enter a value between 0 and 65535 in the Strategy field.
Alert Setup
AMS Device Manager
Configure > Alert Setup
Device Communicator
Configure > Alert Setup
The Alert Setup tab is shown in figure 17.
24
Quick Start Guide
D103470X012
Advertisement
