For The Installer - Nibe EKS 500 L User's And Installer's Manual

For the Installer

General
The water heater consists of a steel vessel, with a copper
lining to protect against corrosion.
The water heater is designed and manufactured for a
maximum cut-off pressure of 10 bar.
Maximum permitted temperature is 90 °C.
The insulation on EKS 500, EKS 750 and EKS 1000 com-
prises Neopor and polyester fleece with a thickness of
100 mm, which provides excellent heat insulation. The
insulation and grey plastic outer cladding can be re-
moved easily to simplify moving the water heater
through doorways, for example.
EKS 500 can be equipped with up to two immersion
heaters and EKS 750 and EKS 1000 can be equipped with
up to three immersion heaters.
The connection diameter is G50 and the maximum im-
mersion heater length for EKS 500 is 650 mm and for
EKS 750 and EKS 1000 is 750 mm.
Transport
EKS 500, 750, 1000 L should be transported and stored
vertically in a dry place. The EKS 500, 750, 1000 L may,
however, be carefully laid on its back when being moved
into a building.
Assembly
The water heater is only designed for upright installation.
The water heater is unscrewed from the pallet and lifted
into position, using the lifting eye.
EKS 500 is equipped with a lifting eye in the top.
The top insulation must be removed to access the lifting
eyes on the EKS 750 and EKS 1000.
Position EKS 500, 750, 1000 L on a firm base that can
take the weight, preferably on a concrete floor or
foundation. Use the product's adjustable feet to obtain
a horizontal and stable set-up.
The area where EKS 500, 750, 1000 L is located must be
equipped with floor drainage.
20-55 mm
30 - 50 mm
18
0 R
0
R
Supplied components
Drain valve with plug
Insulation plug
Cover discs
Plastic cover
H o t w a te r 5 1 °C H M flo w 4 9 (5 0 ) °C
-2 0 + 2
0 R 1
EKS 500, 750, 1000 L | GB
H o t w a te r 5 1 °C H M flo w 4 9 (5 0 ) °C
-2 0 + 2
0 1
R