For The Installer General - Nibe EKS 500 User's And Installer's Manual

3 For the Installer
General
The water heater consists of a steel vessel, with a copper
lining to protect against corrosion.
The water heater is designed and manufactured for a
maximum cut-off pressure of 10 bar.
Maximum permitted temperature is 95 °C.
The insulation on EKS 500, EKS 750 and EKS 1000 is 50
mm thick polyurethane. The insulation can be removed
to make it easier to move the water heater through
doorways, for example.
The outer shell is grey plastic.
EKS 500 is equipped with a lifting eye in the top.
The top insulation must be removed to access the lifting
eyes on the EKS 750 and EKS 1000.
EKS 500 can be equipped with up to two immersion
heaters and EKS 750 and EKS 1000 can be equipped with
up to three immersion heaters.
The connection diameter is G50 and the maximum im-
mersion heater length for EKS 500 is 650 mm and for
EKS 750 and EKS 1000 is 750 mm.
The enclosed kit contains a drain valve and cover discs.
Supplied components
Tapping valve Cover discs
20 EKS 500, 750, 1000 L | GB