Hitachi NEXT Series Instruction Manual page 15

Digital Monitor
Used for basic settings as well
as other various settings in
combination with the LCD monitor.
( 3.3.6)
● ALARM light (green): Blinks
if an alarm failure occurs.
RUNNING CONTROL
ALARM
RESET
FUNC
REMOTE
STR
Press this button to stop the air compressor.
The air compressor will stop after removing the
condensate from the air end.
※This stop button is effective while a stand alone operation.
SELECT/WIDE button/light (yellow)
Press to confirm the measurement
values, shutdown history, and
setting status. ( 3.4.1)
To set the ECOMODE [Energy
saving mode] (Fixed speed type
only), hold down the SELECT/WIDE
button for at least 7 seconds. The
light blinks and ECOMODE is set.
EMERGENCY STOP button
Stops for emergency.
( 3.2.3)
RUNNING MODE
REMOTE
LOAD
［× 10h］
SHUTDOWN
SELECT/WIDE START
2
1
START button
Starts the air compressor.
The START light turns ON while
air compressor is running.
3. OPERATION PROCEDURE [Instrument Panel]
RUNNING MODE Light
● POWER light (yellow): Lights up when the main
power is turned on.
● REMOTE light (green):
ON (glowing) when the REMOTE button is
pressed in order to activate a remote operation.
ON (blinking) when an external remote-operation-
activation switch has been turned on in order to
activate a remote operation. (
● LOAD light (yellow): ON (glowing) when the air
compressor is loading.
● AUTO START light (green):
ON (glowing) while the air compressor is in a stop
due to an AUTO operation,lead/lag operation, or
scheduling operation.
ON (blinking) while the air compressor is in a stop
d u e t o a r e s t a r t a b l e i n s t a n t a n e o u s p o w e r
interruption. (
● SHUTDOWN light (red): Blinks if a shutdown
failure occurs. (
POWER
AUTO START
STOP
Stops the compressor
immediately without unloading.
(
UNLOAD STOP
UNLOAD STOP button
Stops the compressor in normal state.
The compressor stops running
after removing the condensate
from the air end. (
3.4.6)
3.3.3)
3.3.3)
STOP button
3.2.2)
3.2.2)
13