Transceivers, Connectors, And Cables; Transceiver And Cable Specifications; Rj-45 Connectors - Cisco Nexus 9504 Hardware Installation Manual

System Specifications

Transceivers, Connectors, and Cables

Transceiver and Cable Specifications

To determine which transceivers and cables are supported by this switch, see
support/interfaces-modules/transceiver-modules/products-device-support-tables-list.html.
To see the transceiver specifications and installation information, see
interfaces-modules/transceiver-modules/products-installation-guides-list.html.

RJ-45 Connectors

The RJ-45 connector connects Category 3, Category 5, Category 5e, Category 6, or Category 6A foil twisted-pair
or unshielded twisted-pair cable from the external network to the following module interface connectors:
• Switch chassis
To comply with GR-1089 intrabuilding, lightning immunity requirements, you must use a foil twisted-pair
Caution
(FTP) cable that is properly grounded at both ends.
The following figure shows the RJ-45 connector.
Figure 22: RJ-45 Connector
1
◦ CONSOLE port
◦ MGMT ETH port
Pin 1 2 Pin 2
Cisco Nexus 9504 NX-OS Mode Switch Hardware Installation Guide

Transceivers, Connectors, and Cables

http://www.cisco.com/c/en/us/
http://www.cisco.com/c/en/us/support/
87