Table of Contents
Advertisement
IP ADDRESSING
Each device has at least one IP address, which uniquely identifies it from all other devices on the network.
There are several forms of IP addresses, but the most commonly used is IPv4, which consists of 4
numbers (between
DHCP (DYNAMIC HOST CONFIGURATION PROTOCOL)
The address can be set manually on the device itself, or else the device can be assigned one by a master
controller on the network. This master controller is known as the Dynamic Host Configuration Protocol
(DHCP) server.
To use an IP address, a device must know several pieces of data, including the
device will use, the IP address of the Domain Name Server (DNS) where the device can find IP addresses
of other devices, and the IP address of the Default Gateway device through which communications are
routed.
Using
DHCP
means that all these pieces of information are set automatically avoiding the need for
specialist knowledge of IP networking. If
to configure your devices.
DHCP reservation
A
DHCP
server can be configured to always assign a particular
called a
DHCP reservation
cycles and makes a new
SUBNETWORK (SUBNET)
A subnet is a logical division of a network – that is while it might be physically connected to other
subnets, communications traffic from one subnet can be kept separate from comms origination on
other subnets.
A group of the most significant bits of the IPv4 address (the numbers at the start of the address)
specifies the address of a network or subnetwork. This is called the Network Prefix. The remainder
specifies the host – the address unique to the specific device.
For example:
•
on the
.
192
168
•
On the
.
.
55
231
77
The specific parts of the address that are in each portion is defined by the device's 'Subnet Mask'. This
can be expressed as a "bitmask" that is applied by a bitwise AND operation – e.g.
only the last 2 segments of the address apply to the local subnet.
For example,
•
if the address
address, and
2
•
if the address
address, and
3
The network can also be identified by a decimal number following the first
e.g.
.
.
.
/
. This is called
55
231
77
0
24
represents the number of bits allocated for the Network Prefix.
Each segment of an
i.e.
.
.
.
could also be written
192
168
2
54
©ABB 2021 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
and
) separated by dots e.g.
0
255
DHCP
and enables a user to access a device by
DHCP
request.
subnet, an IP address of
192
subnet, IP address
.
55
231
.
.
.
has a subnet mask "
192
168
2
54
.
is the device address.
54
.
.
.
has a subnet mask "
55
231
77
3
is the device address.
Classless Inter-Domain Routing
IP
address represents 8 bits,
.
11000000
FBVi-2U4-4T |
.
.
.
192
168
222
51
is available on your network is the most convenient way
IP address
IP address
.
.
.
refers to device
168
2
54
2
.
.
refers to device
77
3
3
.
.
.
", that means that
255
255
0
0
.
.
.
", that means that
255
255
255
0
(CIDR) notation. The decimal number
.
.
10101000
00000010
00110110
IP Networking
IPv4
address that the
to a specific device. This is
even if the device power-
.
.
54
.
.
.
means that
255
255
0
0
.
is the subnet
192
168
.
.
is the subnet
55
231
77
IP
address on the network –
9
Advertisement
Table of Contents
