Table of Contents
Advertisement
IP NETWORK MENU
CONFIGURATION
This page allows basic
If your network has a
list controllers along with their IP addresses, and can use the hostname to identify the IP address of a
specific controller. By default, all
hostname set to "
FBVi
If your network does not have a
is made up as follows:
•
The first byte of the IP address is set to 10
•
The 6 digits of the numerical part of the serial number grouped into 3 sets of 2 digits to form the
last 3 bytes of the IP address.
For example,
FBVi
also
Configuring the IP connection
mask
in CIDR format. See
Recovery IP Address
If the primary IP cannot be reached – for example if the primary is set to automatic and there is no DHCP
server available, then the user must use the Recovery IP Address to access the Web UI and properly
configure the primary. The recovery is only designed for access to the web UI.
The factory default value is based on the serial number in the same way as the primary, but the Recovery
IP Address should not be changed or disabled unless it interferes with other network operations.
Note:
A button-press reset (see
revert all IP configuration to factory defaults.
©ABB 2021 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
IP
configuration, identifying the current device on the
DHCP
server, click the
Automatic (DHCP)
FBVi
devices leaving the factory are configured to use DHCP, and have a
" followed by the controller's serial number – e.g.
DHCP
server, then the
with serial number
901001A
on page 35. The
Subnetwork (Subnet)
Error! Reference source not found.
FBVi-2U4-4T |
box. You can then use
FBVi901004A
FBVi
controller will use a default
will be allocated the default IP address of
input is also used to specify the
IP Address
on page 9 for a full explanation.
on page Error! Bookmark not defined. will
FBVi Web UI
IP
network.
BACnet
discovery to
IP
address, which
. See
10.90.10.01
subnet
26
Advertisement
Table of Contents
